Approved constructions for structural fire protection
Proven, reliable constructions for safe, standards-compliant fire protection – from standard solutions to bespoke designs.
Complete systems, including accessories, joint systems and project-specific bespoke solutions.
All constructions are based on proven solutions and ensure reliable structural fire protection – even under demanding conditions.
From wall and ceiling constructions and steel cladding to façade, roof and special solutions – for virtually every fire protection requirement.
Well-designed systems, including accessories such as fire-resistant joints and solutions for timber construction, ensure safe, cost-effective implementation.
Custom constructions provide precise solutions for specific geometries, installation situations and project requirements.
Aestuver® constructions
Long-term safety through system solutions
Aestuver® fire protection boards and system solutions provide long-term safety and value retention for your projects. Architects, planners and installers benefit from expert technical advice and comprehensive project support. Certified systems (ETA, AbP, abZ, aBG) guarantee the highest quality. As cement-bonded lightweight concrete boards with the highest weather resistance classification, Type X, Aestuver® fire protection boards stand out for their resistance to weather, frost and water and are fully suitable for long-term use outdoors and in wet areas.
Aestuver® fire protection planner
The Aestuver® fire protection planner significantly simplifies and speeds up the planning of fire protection cladding for steel components. Civil engineers, fire protection planners, project developers and contractors receive not only tailored fire protection solutions but also design and installation information – and the specific material requirements are calculated directly. The application is extremely easy to use.
Frequently asked questions
Clear answers to frequently asked questions about Aestuver® fire protection boards.
Technically, Aestuver® fire protection boards can be used outdoors permanently without an additional coating. For aesthetic reasons, however, we recommend structural weather protection or a suitable coating. Exception: in road tunnels, a surface coating is required for frost and road-salt resistance. Detailed information can be found from page 103 of the Aestuver® fire protection manual.
Coatings with commercially available dispersion-, silicate-, synthetic resin- or acrylic-based products are possible. A deep-penetrating primer is recommended. For skimming the surface, fermacell™ Powerpanel fine surface treatment is suitable in combination with full-surface reinforcement using fermacell™ HD reinforcing mesh. The fermacell™ HD render system is also approved. Application instructions can be found from page 103 of the Aestuver® manual.
According to the European Assessment Documents (EADs), there are four use categories:
Type X: indoors, partially exposed and fully exposed to the weather – the highest requirement level
Type Y: indoors and areas partially exposed to the weather (e.g. covered outdoor areas)
Type Z1: indoors with high humidity or fluctuating temperatures
Type Z2: indoors only, with constant climatic conditions
Aestuver® fire protection boards meet the highest category, Type X (EAD 350142-00-1106).
Aestuver® fire protection boards are available from building materials retailers in Germany, such as specialist dealers for drywall, insulation, roofing and insulation technology.
Depending on the construction, the boards are either fixed board-to-board with staples or screws, or mounted on a metal, timber or concrete substructure. Detailed recommendations on suitable fixings can be found on pages 106–107 of the Aestuver® manual.
More Aestuver® products
Explore more Aestuver® products.