James Hardie® offers holistic solutions for preventive structural fire protection. That is why fire protection products in form of systems are also part of the range.
In the event of a fire, cable systems can be damaged, resulting not only in dense smoke damage but also in highly toxic gases. Within a few minutes, escape and rescue routes can become a deadly trap. In addition, the work of the emergency services is made more difficult or even impossible.

Aestuver® offers the following solutions to ensure that manufacturers of components and systems also meet the high fire protection requirements in this case:

 

Aestuver® Sealing systems

In order to make penetrations through wall and ceiling components fireproof, Aestuver® partitioning systems are used. These room-closing, fire-resistant cable ducts prevent the spread of fire. Aestuver® offers:

  • Combination bulkheads
  • Cable bulkheads
  • Pipe insulations

 

Installation channels (I channels)

Aestuver® Installation channels prevent the transmission of fire from the inside to the outside and protect the surrounding rooms, e.g. escape and rescue routes (fire load clearance). A spillover on e.g. ceiling cavities is prevented. These cable ducts are tested according to DIN 4102-11.
 


 

Fire protection cable ducts for function maintenance (E ducts)

Aestuver® Fire protection cable ducts for function maintenance ensure that in the event of a fire, no fire penetrates into the duct from outside and that the temperatures inside remain low. This ensures that no short circuit occurs or that the power supply is interrupted. These cable ducts are tested according to DIN 4102-12.
 


 

Aestuver Tx® fire-protection board

Träger und Stützenbekleidung mit AESTUVER Brandschutzplatten gem ETA 110458

Trägerbekleidung mit AESTUVER Brandschutzplatten gem DIN 4102

Trägerbekleidung mit AESTUVER Brandschutzplatten gem ETA 110458

Stützenbekleidung mit AESTUVER Brandschutzplatten gem DIN 4102

×